A builder named Zeph Gage has developed a low-cost portal axle for the rear of an XJ Jeep by turning a familiar differential design upside down. The project uses a Ford 9-inch axle housing, geared hubs from a Humvee and HMMWV portal adapters from Jesse Haines Fabrication. It is a rear-only conversion, a detail that is central to how the package fits and performs.
Portal axles place a gear stack behind each driven wheel rather than letting axle shafts and other hardware hang below the chassis. That raises the axle tubes and improves ground clearance. The trade-off is cost: a typical set from companies such as 74Weld runs about $20,000, while Gage's rear unit is described as costing one-fifth of that, or roughly $4,000.
Correcting the direction
The Humvee-style portal uses two gears and reverses the rotation of the input shaft. To make that work with the Ford 9-inch, Gage flipped the differential upside down so the driveline would spin in the correct direction. A Yukon Gear and Axle third member was then bolted to the differential. The arrangement effectively turns low-pinion parts into a budget high-pinion-style unit.
The conversion adds about six inches of clearance. It retains full shock travel, a packaging point that can be difficult with portal axles, and it reduces stress on the differential. The design is expected to be effectively bulletproof, though that is an assessment of the layout rather than a tested claim in the source.
Why only the rear?
Installing a portal axle only at the rear may look unusual, but the approach is common in remote-control rock crawling. Keeping the front solid axle avoids the packaging constraints that arise when adding portal axles to a vehicle that never had them. It also means the builder does not have to limit shock travel to make the front fit, and the ride height does not rise to an extreme level. The rear end gains clearance while the front keeps a more conventional layout.
This is not a bolt-on kit. Gage fabricated brackets and custom-tapped plates, and he used a two-piece brake rotor with a Ford Fusion caliper. The Fusion hardware was chosen partly because it has an integrated electric parking-brake solenoid and because it helps with clearance.
The finished XJ can drive over a five-gallon bucket and still have several inches of clearance to spare. That matters on obstacles where the front can steer around a rock or ledge but the rear might otherwise drag. The project shows how parts-bin engineering and a reversed differential can produce portal-axle ground clearance at a fraction of the usual price.
